GeoVision How do I load default settings on BX series IP camera?
GeoVision
Back to GeoVision Support | Support Home
GV-BX110D
GV-BX120D / 130D Series / 220D Series / 320D Series / 520D-0
Back to GeoVision Support | Support Home
GV-BX110D
- Unplug the power cable and the network cable.
- Press and hold down the Default button on the back panel of the camera.
- Power on the camera using a power supply or PoE cable.
- Wait until the status LED on the front panel of the camera turns off then turns red again. This will take about 10 seconds.
- Release default button.
- Allow camera 30 seconds to boot up.
GV-BX120D / 130D Series / 220D Series / 320D Series / 520D-0
- Unplug the power cable and the network cable.
- Press and hold down the Default button on the back panel of the camera.
- Power on the camera using a power supply or PoE cable.
- Wait until the status LED on the front panel of the camera turns on then off twice. This will take about 30 seconds.
- Release default button.
- Allow camera 30 seconds to boot up.