LincX2PRO/Add Device To Imaxcampro Recorder

Add LincX2PRO Device To Imaxcampro Recorder

Description

These instructions will show you how to add a LincX2PRO Device to a Imaxcampro recorder.

Prerequisites

• LincX2Pro Device
• Imaxcampro NVR, DVR, or XVR
• Completed Initial Setup of LincX2PRO Device

Not Working Functions

• No ONVIF
• No 3rd Party Support for 3rd Party VMS, Recorders, or Video Intercom devices
• No RTSP URL
• No PIR Recording
• No Calls to SmartPSS
• No Calls to Imaxcampro Recorder
• Not compatible with Imaxcampro Video Intercom devices

• Click on "Device Search", it will scan the network and pick up any cameras on it

• Check the box of the camera you are adding and click on "ADD" and you will see the camera populate on the bottom box

• Give it a few seconds and click on refresh to see if it was added properly. As you can see the status light is now green

Method Two:

The second method is used if there's an existing camera and it's password was changed. You will use device search to locate the camera and then go to manual add to change the password it's being added with

• Do a Device Search to locate the camera. Check the camera and click on "Manual Add"

• A popup window will come up and most of the information will be populated. You will just need to change the password, click on save when you're done.

• The camera will now be added

Method Three:

This last method is used when Device Search fails and cannot locate the camera on the network. You will need to type in the camera's information manually.

• Click on Manual Add

• Input all the required information

• After manually inputting the information click on "Save"

• If the information was correct then the camera will be successfully added and have a green status light