GeoVision How do I load default settings on FE series IP camera?
GeoVision
Back to GeoVision Support | Support Home
Back to GeoVision Support | Support Home
GV-FE110/ 420/ 520
- Unplug the power cable and the network cable.
- Remove the cover by unscrewing three screws indicated below.
- Press and hold down the Default button using a sharp object such as a paper clip.
- Power on the camera using a power supply or PoE cable, continue to hold down the Default button.
- Release the Default button when the network status LED light turns off.
- Allow camera 30 seconds to boot up.