GeoVision How do I load default settings on BX series IP camera?


GeoVision
Back to GeoVision Support | Support Home

1.JPG

GV-BX110D
  1. Unplug the power cable and the network cable.
  2. Press and hold down the Default button on the back panel of the camera.
  3. Power on the camera using a power supply or PoE cable.
  4. Wait until the status LED on the front panel of the camera turns off then turns red again. This will take about 10 seconds.
  5. Release default button.
  6. Allow camera 30 seconds to boot up.
2.JPG

GV-BX120D / 130D Series / 220D Series / 320D Series / 520D-0
  1. Unplug the power cable and the network cable.
  2. Press and hold down the Default button on the back panel of the camera.
  3. Power on the camera using a power supply or PoE cable.
  4. Wait until the status LED on the front panel of the camera turns on then off twice. This will take about 30 seconds.
  5. Release default button.
  6. Allow camera 30 seconds to boot up.