GeoVision How do I load default settings on BL series IP camera?

Back to GeoVision Support | Support Home

  1. Unplug the power cable and the network cable.
  2. Loosen the front camera cover and remove the silica gel bag.
  3. Unscrew the fixing screw and pull out the camera module slightly .
  4. Press and hold down the Default button.
  5. Power on the camera using a power supply or PoE cable, continue to hold down the Default button for 50 seconds.
  6. Release default button.
  7. Allow camera 30 seconds to boot up.
  8. Push the camera module back slightly and fasten the fixing screw.
  9. Replace a new silica gel bag and fasten the front camera cover.

Printable Version