Dlink Remote Access Guide for iMaxCamPro DVR's


Port Forwarding using a Dlink router
for Bronze, Gold, and Platinum iMaxCamPro DVR's
Back to Remote Access Guides | iMaxCamPro Support | Support Home
Configuring the DVR to pick up an IP address

Right Click and select Main Menu



Select Setting



Select Network



Check the box next to DHCP and click Save




Power Cycle the DVR

Select Shutdown



Set to Restart system and click OK.




Identifying the IP address

Right Click and select Main Menu




Select Setting



Select Network



Uncheck the box next to DHCP, write down the IP Address, Subnet Mask, and Gateway, and click Save





Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser. If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.

In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router. By default the IP address should be set to 192.168.0.1.




You should see a box prompting you for your username and password. Enter your username and password now. By default the username is Admin, and the password is blank. Click the Log In button to log in to your router. Please visit our Default Router Passwords page if the username and password shown above did not work for you.



Click the Advanced button near the top of the page.



Click the Port Forwarding button near the left of the page.



We will list a series of lines here that will show you exactly how to forward the ports you need to forward. iMaxCamPro DVR requires you to forward the following ports: 80,37777,37778. Go ahead and enter the settings shown above into the Port Forwarding Rules menu.

When you're finished, click Save Settings near the top of the screen to save your changes.

And that's it! You're done!