Linksys Remote Access Guide for iMaxCamPro DVR’s

Port Forwarding using a Linksys router

To setup port forwarding on this router your computer needs to have a static IP address.

Or you can take a look at our Static IP Address guide to setup a static IP address. When you are finished setting up a static IP address, please come back to this page and enter the IP address you setup in the Static IP Address box below.

 

  • Open an Internet browser.
  • Type http://192.168.1.1 in the address bar.
  • Click the Go button or press the Enter key on the keyboard.
  • You are going to be asked to login to the router.

Enter your username and password.

The default username and password for Linksys router are as follows:

 

username: admin

password: password

After you enter the username and password, you will be shown the dashboard or the setup screen.

Click on Applications & Gaming to access the applications and gaming menu.

Once in the Applications & Gaming menu, click on Port Range Forwarding to setup the port forwarding.

On the Port Range Forwarding add two applications, as shown in the picture add one with the following information:

Application Name: DVR

Start Port: 37777

End Port: 37778

Protocol: Both

To IP Address: IP Address of our DVR (Ex. 192.168.1.3)

Enabled: Check

We also add another application for the port 80.

 

After you enter the information, click Save Settings, and you are all set.

To make sure that your ports are open and you will be able to connect remotely to your DVR, you can check if your ports are open visiting the following website: http://www.canyouseeme.org/ 

Check the ports 80, 37777 and 37778.

If you get the success message, you are all set. If not please follow the steps above to be able to open your ports.

Please keep in mind that your Internet Service Provider (ISP) might block some for the ports on your router.

Most residential ISP’s block ports to combat viruses and spam. The most commonly blocked ports are port 80 and port 25.

Port 80 is the default port for http traffic. With blocked port 80 you will need to run your web server on a non-standard port.

If your ISP blocks your port 80 please change the networks settings on your DVR for another port.