How to Install & Setup Remove View Program (GeoVision)


Please install Remote Setup from the Setup CD
Running Setup program, you just need to follow the step by step.

Go Next until Finish. It should be done.
Run RemoteView software

Start -> Program -> Multicam -> RemoteView

How to Use?

RemoteView design for Supervisor watching purpose.
Please Notice this. RemoteView only allow 1 user to access at time.
If you are using WinXPsp1 and cannot see any video picture, please go to our download page to download Patch program.

On the Main System site, please make sure Enable TCP Server (for the RemoteView).
if you are using 56k Modem to direct connect, please make sure Enable Modem Server
After running RemoteView software, you should see this picture.

Click Connect button, Select Internet TCP/IP

if you are using 56k modem to direct connect, please select Dial modem instead. Please make sure main dvr system has modem also.
Running Setup program, you just need to follow the step by step.

Go Next until Finish. It should be done.

Please type your main system IP address.

And, your ID & password.

Click Login. That should be done