The SD500-AIM and SD500-MIM are addressable input modules for use with Silent Knight's IntelliKnight fire control panel. The SD500-AIM and SD500-MIM are designed to be used with pull station, water flow switches, and other applications requiring dry contact alarm initiation devices. The SD500-AIM addressable input module mounts to a 4"-square box. The SD500-MIM mini input module fits inside a single gang box. The modules are Class B supervised, single input contact monitors. Using an EOL resister, they monitor for alarm contact closures and for open circuit wiring fault conditions.
Isolate a short circuit wiring fault on a SLC loop using a SD500-LIM. Normally if the control panel detects a short on the SLC loop the entire loop is disabled. When isolator modules are used and a short occurs on the SLC loop, it will be detected as a trouble but all the SLC devices that are protected by a line isolator module will continue to operate.
The SK-Zone is an addressable two-wire interface module for use with IntelliKnight series fire alarm control panels (FACPs). The SK-Zone allows an IntelliKnight FACP to interface and monitor two-wire conventional smoke detectors. This means you can retrofit an existing building and use existing conventional devices.
The SD500-ANM gives you the flexibility to add notification circuits wherever you need them. The SD500-ANM is a supervised addressable notification device that provides you with additional notification circuits on the IntelliKnight's SLC loop. Controlled by the SLC loop up to 127 SD500-ANM modules can be used on an SLC loop. The SD500-ANM provides a reverse polarity Class A or Class B notification appliance circuit with an aux power input. Each SD500-ANM is provided power from a separate power supply and is controlled by the main panel. Power can be provided near the signaling appliance to reduce the wire gauge requirements or power can come from a main power supply and be controlled separately by the individual notification modules. All of the panels 20 notification patterns can be produced by the SD500-ANM.
The SK-Monitor-2 is an addressable monitor module with two initiating circuits for use with IntelliKnight series fire alarm control panels (FACPs). The SK-Monitor-2 acts as an interface to contact devices, such as waterflow switches and pull stations. The SK-Monitor-2 supports Class B supervised wiring to the load device. Conventional 4-wire smoke detectors can be monitored for alarm and trouble conditions.
The SD505-DUCT addressable duct smoke detector including the SD505-APS Photoelectric Smoke Sensor is used for detecting smoke and products of combustion present in air moving through HVAC air handling system. When smoke is detected in a duct, the unit communicates the condition to the IntelliKnight control panel. The panel, in turn, depending on programming and wiring, turns off fans, blowers, and other devices. Now there's even more power and flexibility available to the IntelliKnight family of products!