GeoVision How do I load default settings on MFD series IP camera?
GeoVision
Back to GeoVision Support | Support Home
GV-MFD110
GV-MFD120 / 130 / 220 / 320 / 520
Back to GeoVision Support | Support Home
GV-MFD110
- Unplug the PoE cable.
- Unscrew the camera’s top cover.
- Press and hold the down Default button.
- Power on the camera using the PoE cable. Wait until the network status LED turns off. This will take about 40 seconds.
- Release default button.
- Allow camera 30 seconds to boot up.
GV-MFD120 / 130 / 220 / 320 / 520
- Unplug the power cable and the network cable.
- Unscrew the camera’s top cover.
- Press and hold the down Default button.
- Power on the camera using a power supply or PoE cable. Wait until the Link and ACT LEDs turn off. This will take about 20 seconds.
- Release default button.
- Allow camera 30 seconds to boot up.