Audio Distribution Systems Accessories

  • LA204RWH White Receiver w/Strobe Light
  • LA204RWH White Receiver w/Strobe Light

  • Product #: 54765
  • White receiver. Built in strobe light ideal for hearing impaired or noisy environments. Just plug receiver into a convenient wall outlet and it's ready for use. LA204RWH (strobe receiver only), allows additional chimes throughout home. Up to three door operation with addition of LA207TWH buttons.
    • 3-1/4" wide x 4-1/2" high x 1-1/2" deep

  • Sale price: $116.99

  • AA-SMG Sound Masking Module for AA120M
  • AA-SMG Sound Masking Module for AA120M

  • Product #: 54733
  • The Atlas Sound AA-SMG sound masking generator module is the perfect solution for small to medium sized masking system when used in conjunction with the AA120M mixer amplifier. The module features selectable white / pink noise, front panel level and EQ trim controls, and EQ insert point for system tuning.

    Additional feature include analog noise generator to eliminate repeating cycles and line level output for distribution to additional amplifiers.
  • Sale price: $252.98

  • ST-CX2 Two Band Active Line‐level Crossover
  • ST-CX2 Two Band Active Line‐level Crossover

  • Product #: 54775
  • The ST‑CX2 is a line‑level two band crossover to drive audio power amplifiers. The input and outputs are balanced and may be connected unbalanced if necessary. The input accepts a +4 dBu line‑level signal. The module operates at nominal unity gain.

    The FULL RANGE output is designed for use with full‑range speaker systems which do not contain a woofer (below 100 Hz). The passband is 100 Hz to 30 kHz, with an equalization adjustment centered at 2 kHz. Through the application of a smile‑curve providing up to 8 dB attenuation through midband audio frequencies, the performance of the whole system may be significantly enhanced.

    The WOOFER output is designed for use with woofers amplified independently of any full‑range speakers. The passband is 40 Hz to 165 Hz when set flat, with an equalization BOOST adjustment centered at 50 Hz.

    For systems also incorporating subwoofers, the LOOP THRU output connects to an input of the RDL ST‑CX2S Subwoofer Crossover. The ST‑CX2 features RDL's SupplyFlex power input configuration for operation directly from ground‑referenced, floating or bipolar 24 Vdc power.

  • Sale price: $300.20

  • ST-MX3 3 Channel Audio Mixer ‐ Line input and output
  • ST-MX3 3 Channel Audio Mixer ‐ Line input and output

  • Product #: 54787
  • The ST‑MX3 is a line‑level mixer module in the STICK‑ON Series of products. It provides audio mixing of three line‑level inputs with individual input gain adjustments. The line‑level output is capable of driving either high or low impedance, balanced or unbalanced loads.

    The ST‑MX3 operates from floating or bipolar dc power.

    For installations with microphone level inputs, use the ST‑UMX3 Universal Audio Mixer.

  • Sale price: $304.83

  • ST-HP3 High Pass Filter ‐ 300 Hz and 500 Hz
  • ST-HP3 High Pass Filter ‐ 300 Hz and 500 Hz

  • Product #: 54778
  • The ST‑HP3 is the ideal choice where line‑level audio filtering needs to be provided at the input of a power amplifier for protection of public address horns against damage from low frequencies.

    The ST‑HP3 has one input and two filtered outputs: 300 Hz high pass and 500 Hz high pass. Both the input and output are balanced, and each may be wired unbalanced if required. The input accepts line‑level (+4 dBu nominal) audio. The module operates at unity gain (balanced input and output). The two outputs may be used simultaneously.

    The ST‑HP3 features RDL's SupplyFlex power input configuration for operation directly from ground‑referenced, floating or bipolar 24 Vdc power.

  • Sale price: $306.20

  • VP-222K 2x1:2 Computer Graphics Video Switcher
  • VP-222K 2x1:2 Computer Graphics Video Switcher

  • Product #: 54744
  • The VP-222K is a high-performance switcher for computer graphics video signals with resolutions up to and exceeding UXGA. It switches one of two inputs to two identical outputs.
  • Sale price: $314.90

  • STM-2 Adjustable Gain Microphone Preamplifier ‐ 35 to 65 dB gain
  • STM-2 Adjustable Gain Microphone Preamplifier ‐ 35 to 65 dB gain

  • Product #: 54786
  • The STM‑2 is a quality low‑noise microphone preamplifier designed for use in commercial sound, broadcast, and recording. The STM‑2 is very flexible, with gain adjustment from 35 to 65 dB, two balanced or unbalanced outputs, and available phantom supply input. Its ultra‑low distortion and lownoise performance make it the best choice, even when larger preamps could be used. The STM 2 supply input is single ended and operates from 24 Vdc. Operation from 12 Vdc is possible with a 6 dB reduction in headroom. Each output drives high or low impedance loads.
  • Sale price: $359.19

  • AU5009-LA lyriQ Keypad in Studio Design, Light Almond
  • AU5009-LA lyriQ Keypad in Studio Design, Light Almond

  • Product #: 54770
  • When installed with the lyriQ Audio System, the keypad delivers high-quality sound inside the home. It features enhanced performance with two on-board class D amplifiers and convenient backlit buttons to indicate unit status. The keypad also enables direct selection of the local source, as well as a convenient whole house button and an RJ45 connection for easy Cat 5 based installation.
  • Sale price: $360.10

  • D-936R Stereo input module, RCA jacks, 4 inputs
  • D-936R Stereo input module, RCA jacks, 4 inputs

  • Product #: 54791
  • The D-936R is a 4 stereo input module designed for use with the D-901 Digital Mixer, etc. It is equipped with standard RCA pin jacks. The D-936R features two stereo transmission modes: 1)Selection of one of the four stereo inputs for transmission to the D-901. 2)Mixing of all four stereo inputs, transmitting the mixed signal to the D-901 through left/right channel outputs. Mode settings and stereo selection are performed at the main frame such as the D-901.
  • Sale price: $374.73

  • VM-50V 1:5 Composite Video Distribution Amplifier
  • VM-50V 1:5 Composite Video Distribution Amplifier

  • Product #: 54742
  • The VM−50V is a high−performance distribution amplifier for composite or SDI signals. It takes one input, provides correct buffering and isolation, and distributes the signal to five identical outputs.
    • Bandwidth − 480MHz (−3dB)
    • Looping Input
    • Rack Kit − RK−1

  • Sale price: $505.12

  • RU-ADA4D Audio Distribution Amplifier
  • RU-ADA4D Audio Distribution Amplifier

  • Product #: 54773
  • The RU‑ADA4D is a four channel stereo audio distribution amplifier with input and output gain adjustments and input level metering. The module may be operated in mono to provide up to eight distributed mono signals. The inputs and outputs are connected on rear‑panel detachable terminal blocks.

    Each of the two line level inputs accepts either a balanced or an unbalanced signal. Each input is equipped with a front panel INPUT GAIN trimmer. Input signal levels between ‑14 dBV unbalanced and +9 dBu balanced may be set to the proper operating level as indicated by a dual‑LED VU meter. This assures ample headroom at all normal operating levels. The maximum input level is + 25 dBu.

    A rear‑panel switch selects between stereo and mono operation. In the mono position, input A (left) is used to drive all 8 output channels. When the module is used in a monaural system, only input A must be wired.

    Audio outputs are isolated from each other and may be wired balanced or unbalanced. Each of the outputs is provided with a front panel screwdriver adjusted OUTPUT LEVEL control. Relative to a balanced +4 dBu output level, this gain potentiometer allows an adjustment range from ‑9 dB to +6 dB. Relative to an unbalanced ‑10 dBV output, each output potentiometer allows an adjustment from ‑3 dB to +12 dB.

    The RU‑ADA4D offers exceptional headroom, very low distortion, excellent crosstalk isolation, wide flat frequency response and extremely low noise with very high common‑mode signal rejection. It provides exceptional audio performance for the most critical applications in a professional audio environment.

    The RU‑ADA4D operates from 24 Vdc connected through a rear‑panel detachable terminal block.
  • Sale price: $630.35

  • EQM131 1/3 Octave Graphic Equalizer
  • EQM131 1/3 Octave Graphic Equalizer

  • Product #: 54735
  • The EQM131 will provide basic system equalization for sound masking or general public address applications at an amazingly affordable price.

    The 1RU tall EQM131 is easily connected to any system via rear panel balanced TRS and XLR jacks. Unbalanced RCA connections are also provided for use with -10dBV equipment. Front panel mounted LPF/HPF and level controls are provided along with a switch for +/-6 or +/-12dB operation and 31 sturdy 20mm filter slide controls.

    The ISO centered 1/3 octave bandwidth-constant Q filter design minimizes interaction between filters yet is still wide enough for creation of correction curves.

    When used with the Atlas Sound AA120M mixer amplifier and AA-SMG sound masking module, the EQM131 can be used to create a 1/3 octave masking spectrum which is fed directly to the AA120M amplifier section. Paging or music inputs can receive high frequency shelving equalization for better intelligibility from the AA120M front panel controls. The page/music inputs and masking module output can then be summed without affecting the masking source spectrum equalized by the EQM131.
  • Sale price: $633.41

  • ATW-A49 UHF Wide-band Directional LPDA Antennas
  • ATW-A49 UHF Wide-band Directional LPDA Antennas

  • Product #: 54739
  • Pair of UHF wide-band directional LPDA (log periodic dipole array) antennas provide enhanced signal pickup for UHF wireless systems throughout a wide band range (440-900 MHz). Each antenna paddle is matched to 50 ohms impedance with an integral high-quality low-loss BNC connector; 6 dB gain. For permanent or temporary installation; mounts to 5/8"-27 threads.
  • Sale price: $751.17

  • MPFD35 1" Deep Micro Perf Door for 35RU FMA, 100, 200, 500, and 700 Series Racks
  • MPFD35 1" Deep Micro Perf Door for 35RU FMA, 100, 200, 500, and 700 Series Racks

  • Product #: 54736
  • The Atlas Sound MPFD35 vented rack door is designed for use on the 100, 200, 500, 700, WMA and FMA series cabinets. The MPFD series combines the benefits of vented cooling with the ability to see LED's, TFT's or CRT's housed in the rack via the integral perforated steel mesh panel. A 16GA metal door frame provides exceptional strength to the door assembly.
  • Sale price: $781.78

  • ATW-DA49 UHF Antenna Distribution System
  • ATW-DA49 UHF Antenna Distribution System

  • Product #: 54740
  • The ATW-DA49 is a UHF (wide-band 440-900 MHz) active unity-gain diversity antenna distribution system that enables one pair of antennas to feed multiple wireless systems. Provides two “1-in, 4-out” RF channels; connects a pair of antennas to as many as four wireless receivers. Either passive or active antennas may be used. Both input jacks offer switchable +12V DC output on their center pins to operate Audio-Technica powered antennas or other in-line RF devices if desired. The unit features all-metal construction for extreme durability and protection from radio frequency interference.

    The ATW-DA49 is designed to complement Audio-Technica 2000 and 3000 Series wireless systems. It is also suitable for many other wireless systems operating within the 440-900 MHz range.

    Includes ten RF cables, front-mount antenna cables and connectors, four DC power cables, +12V DC desktop power supply with detachable IEC power cable, and ATW-RM1 rack-mount hardware kit to permit attachment in a standard 19” rack space.
  • Sale price: $898.78

  • A-906MK2 MIXER / AMPLIFIER MODULAR 60W
  • A-906MK2 MIXER / AMPLIFIER MODULAR 60W

  • Product #: 54790
  • The mixer/amplifier shall have eight mixer input ports and shall be capable of operation from a
    110/120 V, 50/60 Hz line. The amplifier shall meet the following performance criteria: Power
    output shall be 60 W at less than 0.5% THD from 20 to 20k Hz (direct output) or 50 to 20k Hz
    (transformer output). Frequency response shall be + 1 dB from 20 to 20k Hz (direct output) or 20
    to 15k Hz (transformer output). Load impedance shall be 4, 8, 10.4 (25 V line) or 81.7 (70.7 V
    line) ohms. Load voltage shall be 15.5, 21.9, 25 or 70.7 V. Output noise shall be 90 dB below
    rated output when all gain controls are off. Plug-in accessory modules designed for use with the
    mixer/power amplifier shall utilize the latest in surface mount component technology and shall
    include microphone, line and special function models. The mixer/amplifier shall be rack-mounted
    using an optional rack-mounting bracket. Dimensions (W x H x D) shall be 16.5” x 3.9” x 14.1”
    (420 x 99.1 x 358 mm) and weight shall be 21.2 lbs. (9.6 kg).
  • Sale price: $1,112.23

  • NC300WH Nutone NC300 CD Changer - White
  • NC300WH Nutone NC300 CD Changer - White

  • Product #: 54767
    • Can be used with both the NM200 and NM100 series Master Stations.
  • Sale price: $1,302.61

Worldeyecam Logo
call us today 1-888-211-2288
Call for Free System Design
Get the Right Equipment
1st and Save Thousands

FREE UPS Shipping On Orders Above $500